Support this website by joining the Silver Rails TrainWeb Club for as little as $1 per month. Click here for info.



This website has been archived from TrainWeb.org/freemoslo to TrainWeb.US/freemoslo.

Free-Mo Risers

The free-mo standards state that you modules needs to adjust for a top of rail height from 50 to 62 inches in 3/4 inch increments. I designed this riser to use on modules that do not have legs that will adjust the full 12 inches.

The concept is easy. This is a series of 24 inch long pieces of 3/4 ply wood. The get progressively wider to form a pyramid for stability. There are also two 1 inch dowels down the middle to keep the pieces from siding off each other. I have not yet built one of these but plan to soon.

Here is a 3D view of the riser Leg Riser 3D view
Here is a cut layout on a 4 X 8 Sheet of plywood. I laid the pieces out with a 1/8 inch blade spacing.  Leg Riser Cut Layout I would start by cutting the board into two 24 inch wide strips. I would then cut the pieces from there. The hardest part will be drilling all the holes so that they line up.
 
Return to Free-Mo-SLO Home Page
 Page Last Updated 12/19/2004
ad pos61 ad pos63
ad pos62 ad pos64



Support this website by joining the Silver Rails TrainWeb Club for as little as $1 per month. Click here for info.